QUESTION 1
Which of these represents an IPv6 link-local address?
A. FE80::380e:611a:e14f:3d69
B. FE81::280f:512b:e14f:3d69
C. FEFE:0345:5f1b::e14d:3d69
D. FE08::280e:611:a:f14f:3d69
Answer: A
Explanation:
Understanding IPv6 Link Local Address
Reference:
https://www.cisco.com/en/US/tech/ tk8 72/technologies_configuration_example09186a0080ba1d07.s
html
The purpose of this document is to provide an understanding of IPv6 Link-local address in a
network. A linklocal address is an IPv6 unicast address that can be automatically configured on
any interface using the linklocal prefix FE80::/10 (1111 1110 10) and the interface identifier in the
modified EUI-64 format. Link-local addresses are not necessarily bound to the MAC address
(configured in a EUI-64 format). Link-local addresses can also be manually configured in the
FE80::/10 format using the ipv6 address link-local command.
QUESTION 2
What is a valid HSRP virtual MAC address?
A. 0000.5E00.01A3
B. 0007.B400.AE01
C. 0000.0C07.AC15
D. 0007.5E00.B301
Answer: C
Explanation:
Hot Standby Router Protocol Features and Functionality
https://www.cisco.com/en/US/tech/ tk6 48/ tk3 62/technologies_tech_note09186a0080094a91.shtml
HSRP Addressing
In most cases when you configure routers to be part of an HSRP group, they listen for the HSRP
MAC address for that group as well as their own burned-in MAC address. The exception is routers
whose Ethernet controllers only recognize a single MAC address (for example, the Lance
controller on the Cisco 2500 and Cisco 4500 routers). These routers use the HSRP MAC address
when they are the Active router, and their burned-in address when they are not.
HSRP uses the following MAC address on all media except Token Ring:
0000.0c07.ac** (where ** is the HSRP group number)
QUESTION 3
When a router undergoes the exchange protocol within OSPF, in what order does it pass through
each state?
A. exstart state > loading state > exchange state > full state
B. exstart state > exchange state > loading state > full state
C. exstart state > full state > loading state > exchange state
D. loading state > exchange state > full state > exstart state
Answer: B
Explanation:
Why Are OSPF Neighbors Stuck in Exstart/Exchange State?
Reference:
https://www.cisco.com/en/US/tech/ tk3 65/technologies_tech_note09186a0080093f0d.shtml
QUESTION 4
What Netflow component can be applied to an interface to track IPv4 traffic?
A. flow monitor
B. flow record
C. flow sampler
D. flow exporter
Answer: A
Explanation:
QUESTION 5
What are three reasons to collect Netflow data on a company network? (Choose three.)
A. To identify applications causing congestion
B. To authorize user network access
C. To report and alert link up / down instances
D. To diagnose slow network performance, bandwidth hogs, and bandwidth utilization
E. To detect suboptimal routing in the network
F. To confirm the appropriate amount of bandwidth that has been allocated to each Class of
Service
Answer: A,D,F
Explanation:
Click here to view complete Q&A of 200-001 exam
Best Cisco 200-001 Certification, Cisco 200-001 Training at certkingdom.com
